FAQ

What am I supposed to see in an x-ray while working with 3D Bond™?

When 3D Bond™ is used on its own, the material is completely resorbed and replaced by the patient’s own bone, which is apparent while viewing an x-ray.

Approximately a week post-operation, a radiolucent shading in the circumference can be noticed in an x-ray. This shading will expand up to the fourth week when the entire area will be completely radiolucent. It seems as though the material has completely disappeared, but this is not the case. This is the un-calcified osteoid. Gradually, calcification of the area will take place, so that up to three months after implantation, the entire area will be radiopaque in the x-ray, with an identical appearance to the adjacent native trabecular bone.

Is it possible to use 3D Bond™ as a membrane?

Most certainly.

What is 3D Bond™ and why should I work with it?

3D Bond™ is a cementable, osteoconductive bone substitute, made of pure Biphasic Calcium Sulfate; the only one of its kind that can set in the presence of blood and saliva. The material is completely resorbed within 4-10 weeks, coinciding with the time period it takes for the bone to form. The outcome is a complete replacement of the graft with the patient’s own bone.

The medical use of Calcium Sulfate has the longest history in the augmentation field, with over 120 years of use in the areas of Orthopedics, Plastics, Oncology, and Maxillofacial medicine. This material has been studied and documented most extensively and is the only one that is associated with thousands of articles in various areas of medical literature.
Throughout the years there has been a constant insistence on working with Calcium Sulfate due to the extraordinary features that distinguish it from currently existing augmentation materials. Notwithstanding, the material in its basic form has two prominent drawbacks; namely, its inability to harden as a cement in the presence of blood and saliva existing in the oral environment and the materials fast resorption rate.

The development of 3D Bond™ originated from a clear clinical need to simplify the complexity of today’s augmentation procedures, shorten the working time as well as the recovery time. The development of this material was a process of over 15 years of intensive research, focusing on the use of pure raw material without any additives or accelerators. The outcome is a superior bone graft material that has the ability to set instantly in the presence of blood and saliva.

2 thoughts on “FAQ

  1. Rafik Said
    Rafik Said says:

    I used bond apatite today for the first time and it didn’t harden at all at the surgical site, and kept almost flowable about 20 minutes.
    How could that be?

  2. Augma
    Augma says:

    In order for the material to harden properly it should be used as follows:
    During activation the shaft of the syringe should be advanced until the first piston reaches the blue line. Then the cap is removed, and the material should be injected into the site. Immediately place on it a dry gauze, not too folded, simply in two layers. Then press strongly with a finger on top of the gauze for 3 seconds, and again with a periosteal elevator for an additional 3 seconds. That’s all you need to do and the material will set instantly. It will never be hard like a stone, but it is definitely stable. During suturing, if the material breaks, place a dry gauze on it and press for one second before continuing to suture.

    If the material didn’t harden, it’s probably because the pressure with the gauze was not done immediately. As such, the crystals are soaked with blood and it will not set properly, and will be flowable.

    Please see our online course for more instructions on proper use.

Leave a Reply

This site uses cookies to offer you a better browsing experience. By browsing this website, you agree to our use of cookies.